Ready-to-assemble to popular SENCO, DeWalt, Milwaulkee, and Makita screwdrivers.     Drives 1" — 2" screws     Just turn the thumb screw to regulate the precise amount of countersink     Easily adjusts for different screw sizes     Provides added comfort and reduced exertion     Feed System snaps off for fast bit access, or to back out driven screws     Saves knees - lets you stand while doing flooring and decking   Click here for a list of corded tool accessories   Click here for detailed information.   Drives 1" — 2" Screws               Cement Board Drywall Floor Sheathing Underlayment   Operation Manual   Parts Chart   Product Sheet - English   Product Sheet - Spanish		Click here to view animation*.     *Requires Macromedia Flash plug-in.     Click here for a printable version**.     **Requires Acrobat Reader.     Item Code: 790012N     Weight: 1.3 lb (.6 kg)     Height: 7" (178 mm)     Length: 10-1/2" (266 mm)     Width: 2" (50 mm)     Fastener Capacity: 50 screws per strip     Screw Lengths: 1" — 2" (25 mm — 50 mm)     Screw Diameters: #6, #7, #8       Weight: 3.3 lb     Height: 7" (178 mm)     Length: 29"     Width: 2" (50 mm)     DS200 comes with: 1 screw-feed system 2 bits 3 adapters Flooring Extension can be purchased separately     Switch to FORWARD gear (not REVERSE).       Use proper hand position. 1. Pull trigger first. 2. Then push down on the screw.       Keep tool perpendicular to the work surface. Keep the bit squarely seated. If it begins to spin out, stop immediately. Continuing the drive will only damage the bit. Push down firmly during the drive. Continue to push firmly until tool clutch disengages. Lift tool straight up from work piece to avoid binding the bit and inadvertent pull-out.

SENCO Web Site Home | Features | Screws | Applications | Where to Buy | Contact Us SENCO Legal © 2004, SENCO Products, Inc. Questions, e-mail web site comments to our webmaster ccrimmel@senco.com